When the fur shoes are dripped with oil and dirt, mix alcohol and yellow rice flour into a paste and apply it to the upper. After drying, brush off the yellow rice flour and remove the dirt. If your fur shoes are dripped with oil but not too dirty,...
When the fur shoes are dripped with oil and dirt, mix alcohol and yellow rice flour into a paste and apply it to the upper. After drying, brush off the yellow rice flour and remove the dirt. If your fur shoes are dripped with oil but not too dirty, just wipe them dry with a regular clean cleaning cloth. Tips for cleaning fur shoes - How to clean oil stains for fur shoes
How to clean fur shoes
It is more troublesome to clean fur shoes, and requires a lot of patience. You can perform the following steps:
1. De-ash. (Available with a vacuum cleaner)
2. First support it with shoes.
3. Use a special brush. Pay attention to the copper wire surface mainly dealing with areas with heavy stains and areas that are polished. First brush with the rubber side in one direction, and use the sides of the side seams. Heavy hard circles on the stains, and then rub them with copper wire.
4. Wipe it with a wet sponge and wet the upper. The purpose is to mainly treat water-soluble substances.
5. Shake the cleaner and spray it on the surface. Use a rubber brush to brush back and forth to remove stains on both sides of the fiber, and suck the dirty foam dry with a damp sponge.
6. Hang for more than ten minutes, and when the hair is slightly dry and it is a little wet, brushing it with a rubber surface in one direction to spread and organize it.
7. Hang for half an hour, and after the upper is dry, plug in the newspaper to protect the shoe, and spray evenly with renewal 15 cm away from the shoe. The renewing agent contains gloss agents, colloids (enhances the adhesion of other substances), pigments, solvents (soluble mixed substances), etc. The purpose of spraying renewing agent is mainly to make up for color. Black shoes will easily turn white after wearing them for a long time, so it is best to use the original color updater.
8. After drying, brush with rubber to make the color consistent.
9. Finally put desiccant and collect
Tips for cleaning fur shoes
How to clean fur shoes? Let me tell you the tips for cleaning fur shoes:
First use a raw rubber brush to remove the floating ash, shake it evenly before using it, and spray it evenly about 15CM away from the leather surface. (Fill the cage in the shoe with a soft cloth or newspaper before use) This type of care product can be purchased in general supermarkets except for special leather shoe care stores.
Follow the direction of fur growth, use a pig brown soft bristle brush to remove the floating ash on the skin. If you find that the leather fur is white after long-term use, how to maintain these fur shoes? Use a copper wire brush to gently scrape the fluff at the white hair in the direction of the fur growth (this is a special method of use and should be used as much as possible). Since suede is a natural two-color effect, even if there is a little white hair, it can be regarded as the characteristics of the leather.
How to clean oil stains on overfur shoes
The overfur shoes are dripped with oil, and they cannot be wiped off if they are dry. You can first scrub with a damp cloth, then scrub it and put it in a ventilated and cool place to dry. When the leather upper seems dry but not dry, dip the hard-bristled shoe brush with some translucent powder and brush it lightly on the upper, and the translucent will become fluffy. After continuous blowing and drying, the hair can be restored to its original state.
When cleaning translucent shoes, it is recommended to use a special cleaner for translucent shoes. Shake it well and put it on the upper. If the translucent shoes are dripped with oil, use the shoe brush to repeatedly brush the rubber surface to remove stains on the fiber surface. Heavy kneading the stains in circles and then kneading them with copper wire. Dirty foam is sucked dry with a damp sponge. Hang for more than ten minutes, and when the hair is slightly dry and it is a little wet, brushing it with a rubber surface in one direction to spread and organize it. Hang for half an hour.
After cleaning the fur shoes, dry them for another half an hour. After the upper is dry, plug in newspaper protection in the shoes, and spray evenly with renewal 15 cm away from the shoes. If the fur shoes are oiled, they need to use a refresher. The purpose of spraying renewing agent is mainly to make up for color. Black shoes will easily turn white after wearing them for a long time, so it is best to use the original color updater.
Tips for removing dirt from overfur shoes:
When the overfur shoes are dripped with oil and dirt, mix alcohol and yellow rice flour into a paste and apply it to the upper. After drying, brush off the yellow rice flour and remove the dirt. If your fur shoes are dripped with oil but not too dirty, just wipe them dry with an ordinary clean cleaning cloth, which is unexpectedly good.
